CA Dealer Power Up Binder - Flipbook - Page 52
Fixture Assembly
ASSEMBLY INSTRUCTIONS
1
Lay both 8’ slotted uprights on the floor. Attach one base foot to the bottom front of each 8’
slotted upright.
FOOT
BOTTOM OF
8’ UPRIGHT
2
FOOT AND 8’ UPRIGHT ASSEMBLY
Insert the prongs at each end of the bottom spanner into the bottom inside slot of each 8’ upright.
BOTTOM SPANNER
8’ UPRIGHT
FOOT
3
Insert prongs at each end of one center spanner to the inside of the 8’ slotted uprights,
approximately 2 feet above the bottom spanner.
CENTER SPANNER
BEFORE PROCEEDING
TO STEP 4:
8’ SLOTTED UPRIGHT
BOTTOM SPANNER
BASE FOOT
The lower peg board piece will be
installed by sliding it between the 8’
uprights from above.
If adequate ceiling height is not
available, the assembly must be laid
down on the floor.
